Implementing and Administering Cisco Solutions (CCNA) - Lab Topology

 

Lab Topology

Lab Outline:

  • Get Started with Cisco Command-Line Interface (CLI)
  • Observe How a Switch Operates
  • Perform Basic Switch Configuration
  • Implement the Initial Switch Configuration
  • Inspect TCP/IP Applications
  • Configure an Interface on a Cisco Router
  • Configure and Verify Layer 2 Discovery Protocols
  • Implement an Initial Router Configuration
  • Configure Default Gateway
  • Explore Packet Forwarding
  • Troubleshoot Switch Media and Port Issues
  • Troubleshoot Port Duplex Issues
  • Configure Basic IPv6 Connectivity
  • Configure and Verify IPv4 Static Routes
  • Configure IPv6 Static Routes
  • Implement IPv4 Static Routing
  • Implement IPv6 Static Routing
  • Configure VLAN and Trunk
  • Troubleshoot VLANs and Trunk
  • Configure a Router on a Stick
  • Implement Multiple VLANs and Basic Routing Between the VLANs
  • Configure and Verify Single-Area OSPF
  • Configure and Verify EtherChannel
  • Improve Redundant Switched Topologies with EtherChannel
  • Configure and Verify IPv4 ACLs
  • Implement Numbered and Named IPv4 ACLs
  • Configure a Provider-Assigned IPv4 Address
  • Configure Static NAT
  • Configure Dynamic NAT and Port Address Translation (PAT)
  • Implement PAT
  • Log into the WLC
  • Monitor the WLC
  • Configure a Dynamic (VLAN) Interface
  • Configure a DHCP Scope
  • Configure a WLAN
  • Define a Remote Access Dial-In User Service (RADIUS) Server
  • Explore Management Options
  • Explore the Cisco DNA™ Center
  • Configure and Verify NTP
  • Configure System Message Logging
  • Create the Cisco IOS Image Backup
  • Upgrade Cisco IOS Image
  • Configure WLAN Using Wi-Fi Protected Access 2 (WPA2) Pre-shared Key (PSK) Using the GUI
  • Secure Console and Remote Access
  • Enable and Limit Remote Access Connectivity
  • Secure Device Administrative Access
  • Configure and Verify Port Security
  • Implement Device Hardening